Pages

Kamis, 15 September 2016

Chines Part I



After learning of Teds broken chine when attempting the bend, I decided to laminate the chines to make for easy bending. So I cut my chine material to rough length, about 12, and then ripped them to 3/8" thick. The cutoff pieces were about 1/4+" thick. I then soaked all four pieces in the 4" soaking pipe, stem end first, for a couple of days to noodle them up a bit.


I borrowed the soaking pipe from Ted. By hanging it in the stairwell, it can be loaded with long pieces of wood, filled with water and not get in anybodys way. Also, its a lot easier to keep the water in it if its not horizontal.


After soaking, the chine material was put on the boat and bent into place. The two layers of thin material bent easily into position on the frames and up against the stem. They were left to dry for a couple of days while I did other things like work for a living.


When it came time to figure out how to fit the chines at the stem, I decided that without having the shears in place, it was hard to judge how much twist to put into them. I decided that procrastination was a good approach to the question, and bending and installing the shears first might answer the question or provide enough time to figure it out.

The picture shows the chines held in place and the one layer of the shears bent and clamped in place. On the left is a previously bent shear just resting in place waiting for the glue-up to take place.

Related Posts by Categories

0 komentar:

Posting Komentar