After 6 coats of varnish, I was tired of that operation and needed to get the sides done. The plan was to do some paint graphics to hide some fiberglass reinforcement tape at the plywood butt joints on the sides and at the side to transom junction. The tape at the bow seemed to fade away sufficiently to ignor it. I tried to get a graphic designer to work on a design with me, but he must be busy as he was not returning my recent calls. So my wife, Vicky said "Lets grab some paper, colored pencils and work out our own design"....and so we did." I added a beer to the operation to loosen up the creative juices. Then we went to an art supply store to get some 1/4" wide artist tape to do the masking in the curved areas.
After the curved areas were done another pass of wider tape was put down and then some masking paper over all the varnish areas to protect from the roller and splatter. I used 3/4" wide tape to define the boot stripe and then masked above and below it and then removed it. The butt end of a x-acto knife was used to burnish the edge of the tape to prevent paint bleed. (This worked well but I would recommend that the burnishing be done twice as I had a few areas where I got some bleeding where I must not have gotten the tape edge down tight).
After putting down a coat of primer and sanding, a coat of white was painted on just using a foam roller. The bubbles did not pop as the paint can said it would, so after sanding, the second coat was applied with a roller and tipped off with a foam brush - much better. Then the blue portion was masked off and painted. I decided that the blue areas will probably be finshed off with a border of 1/4" wide white vinyl tape as masking off a consistent narrow band seemed impossible. The blue dried overnight and a second coat
applied. Next day it was mask removal time to see what was under the mess of paint, 
paper and tape. Looks pretty cool I think.
After the curved areas were done another pass of wider tape was put down and then some masking paper over all the varnish areas to protect from the roller and splatter. I used 3/4" wide tape to define the boot stripe and then masked above and below it and then removed it. The butt end of a x-acto knife was used to burnish the edge of the tape to prevent paint bleed. (This worked well but I would recommend that the burnishing be done twice as I had a few areas where I got some bleeding where I must not have gotten the tape edge down tight).
After putting down a coat of primer and sanding, a coat of white was painted on just using a foam roller. The bubbles did not pop as the paint can said it would, so after sanding, the second coat was applied with a roller and tipped off with a foam brush - much better. Then the blue portion was masked off and painted. I decided that the blue areas will probably be finshed off with a border of 1/4" wide white vinyl tape as masking off a consistent narrow band seemed impossible. The blue dried overnight and a second coat
applied. Next day it was mask removal time to see what was under the mess of paint, paper and tape. Looks pretty cool I think. Later when I talked with the graphics guy, he showed me how to mask out a border band so I could paint it so I would have a perfect color match. He showed me how to mask using 1/4" vinyl tape that he gave me that bends easily without puckering. A couple of hours later I had another white strip outlining the blue areas.
Final side work was a 1/4" red-orange stripe put on by the graphics guy and the word "Squirt" done in a 50s retro script lettering.
Final side work was a 1/4" red-orange stripe put on by the graphics guy and the word "Squirt" done in a 50s retro script lettering. 
0 komentar:
Posting Komentar